![]() ![]() If the ruler has a center control point, it can be set to your current pen position or reset to the center of the screen via the Set/Reset Ruler Center general shortcuts. You can configure the Ruler Accuracy Off/Restore general shortcut to quickly toggle this parameter. Set it to 0 if you don't want your line to snap to the ruler at all, but still wish to see the overlay guide. The closer this value gets to 0, the more of your original input gets mixed in, letting you add imperfections to make the lines look more natural. When set to a value of 1, the line you draw will be fully projected onto the selected ruler. You'll also notice that all ruler modes have a common Accuracy parameter. via individual keyboard shortcuts, which can be configured via Settings/Edit Shortcuts/Ruler Shortcuts.via the on-screen control point graphics, while holding the control key.Via the parameter slider or numeric box in the UI.They can be controlled the following ways: Most of the ruler modes have parameters that control how the ruler behaves. While you're there, be sure to enable Direct2D for improved performance (if you experience any lag, you may try a different adapter via the list, or try turning off Direct2D). ![]() You can control its opacity and other settings via Settings/Edit Overlay Settings. These are rendered on a transparent overlay window. When a ruler is active, guides will be displayed over your canvas. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |